Recent content by Force-fed

Pm sent

Ive had this set in for about a month, first off i had a bad mid woofer right out of the box, brand new from woofers etc. after dicking around with them for 3 weeks to send me 1 under warranty, the other woofer is now crackling and sounds like its blown. I pulled the speaker out, looks fine just...

Pm sent

Front comps are running off an old zed built usa 2100, on my way home today the speakers kind of went in and out and sounded way off, then fine, then quiet, then midbass was fine but tweeters were quiet, and when i turned the balance to the right it would start to move the sound to the right but...

Here's a vid, any1 know what would cause this? Curious

Well it wasnt an interference issue at all, move wires away from power block, still popped. Disconnected woofer, ran tweeter through, crossover, works fine. Ran a diff speaker on woofer wire, works, hook up id woofer, just pops as soon as amp turns on. How did i end up with 1 bad sub right out...

Disconnected the drivers side channel and just ran the passenger and it worked, did a little investigating and it turns out there is a big fuse block on the drivers side under dash where i ran my wire, it must have interfered and ran the crazy signal noise over to the passenger side too. Its...

I dont, i was going to go buy a cheap set of speakers to hook up inplace of the id's just to rule those out or see if they are infact the problem, other than that i cant think of anything else

First off hu is jvc kw av61, 2 sa12 subs on db a7 2000.1 amp, just installed id ctx65 front components and a usa2100 amp. Power is on the driver side, rca/speaker on the passenger side. I ran rca's from hu front out to amp, left channel +/- from amp to "in" +/- on crossover, then woofer out and...

any left? need 2, dual 4 or dual 2

im building a box for 2 sa12's for my wagon, subs up ports back sounds best with the single I have in now. I want to use aero ports, and I never have before, can any1 tell me if my math is close or not? I plan on 4 cubic feet after the speaker and port displacement... .75 mdf box width-32"...

u can use a dmm to get an idea of what the amp is putting out, use a test tone and listen for the speaker to clip, search for a vid to show you how if you don't know what youre listening for, with out setting the gain with an o-scope, that's gunna have to do

you can measure the wattage with a dmm, but if im not mistaken the only way to tell if its clean or not is to use an oscilloscope, they can take 1500 clean, but if its clipping you'll damage it

I figured that, might just get another sa12 and build a box for 2, just didn't want to take up my whole hatch, o well. thanks for the input. if I go that route would the a7 be enough for 2? also electrical, stock alt is a 120 amp, and battery is a group 94r, thanks

I have 1 sa12 running off a db a7 2000.1, im looking for louder, because of what I need to carry in my hatch, I can only go with a single 12" the box I built is 2.0 ft^3, ported, tuned to 35htz. is it worth it to upgrade to a dc lvl 4, or z12 v.3? I don't want to have to buy another amp, or go...