Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
2000 Camry Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="HardofWhoring" data-source="post: 8866184" data-attributes="member: 674149"><p>Dynamat is all I use now. It costs more, and there is stuff that works better, but I like what it does, and know that it will work well for a long time. As far as butyl only, not sure if all other stuff can claim the same temperature range. </p><p></p><p>I also didn't think about that heater option. OP should go for a drive to keep adding to the warmth of the work area, and run the heater on high for as long as they can handle it to get everything else heated up. </p><p></p><p></p><p>I have a mini personal heater, and kind of sounds like what your plan is. That's going to be a very slow process then. You will want that on the door, but not too close to where it could effect the paint, perhaps from the inside. I would be cautious of any fabric material that could be around, however you do that. Conduction would work best, perhaps a dryer heated towel to start off with.</p></blockquote><p></p>
[QUOTE="HardofWhoring, post: 8866184, member: 674149"] Dynamat is all I use now. It costs more, and there is stuff that works better, but I like what it does, and know that it will work well for a long time. As far as butyl only, not sure if all other stuff can claim the same temperature range. I also didn't think about that heater option. OP should go for a drive to keep adding to the warmth of the work area, and run the heater on high for as long as they can handle it to get everything else heated up. I have a mini personal heater, and kind of sounds like what your plan is. That's going to be a very slow process then. You will want that on the door, but not too close to where it could effect the paint, perhaps from the inside. I would be cautious of any fabric material that could be around, however you do that. Conduction would work best, perhaps a dryer heated towel to start off with. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
2000 Camry Build
Top
Menu
Home
Refresh