D amp replacement for my mb quart q4.150

  • 4
    Participant count
  • Participant list
I do not know about those two but I just read a very good review on the Precision Power Phantom P900.4. I think it was on pasmag.com, page 8 or 9 in the reviews section. Too late to give you a link, sorry. The numbers are very good and so is the price. As a matter of fact I was just about to order it when I read that the input voltage was 280mV-7.8volts. That is no big deal for anyone with a 4V HU. I thought that would be no problem for me either. However, my new Alpine with 3 sets of preamp outputs has only 2V. Personaly, I never thought to look at that when I made the purchase, so much has changed since the 90's. If you have a 4V head unit ypu should consider PPI. Looks dam good too.

 
I do not know about those two but I just read a very good review on the Precision Power Phantom P900.4. I think it was on pasmag.com, page 8 or 9 in the reviews section. Too late to give you a link, sorry. The numbers are very good and so is the price. As a matter of fact I was just about to order it when I read that the input voltage was 280mV-7.8volts. That is no big deal for anyone with a 4V HU. I thought that would be no problem for me either. However, my new Alpine with 3 sets of preamp outputs has only 2V. Personaly, I never thought to look at that when I made the purchase, so much has changed since the 90's. If you have a 4V head unit ypu should consider PPI. Looks dam good too.
HUH? You didn't buy the Phantom because of....why again?? 2v is fine with that amplifier. The gain is adjustable from .3 volts all the way up to almost 8 volts. Your 2volts fall right in there. All you do is set the gain by ear.

 
Polk:

pad40004.jpg


NVX:

jad8004.jpg


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Resonix is supposed to be the bees knees, but it is a little $$. If I was doing the whole car, probably would shell out for the entire resonix...
25
3K
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
152
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
385
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
689

About this thread

cp281080

Junior Member
Thread starter
cp281080
Joined
Location
buenos aires argentina
Start date
Participants
Who Replied
Replies
6
Views
1,544
Last reply date
Last reply from
cp281080
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top