Need Help on new system install

  • 3
    Participant count
  • Participant list
I'm planning on getting 2 Alpine SWR-12D4's. Would a SSL EVO2200.2 amp be adequate for this? I am also planning on getting a 2.0 farad capacitor. I don't want to put more than 1000-1100 watts RMS out right now because I don't have the money to upgrade all of my electrical. If I'm right this should put 550 RMS into each sub at 4 ohms stable. It's a 2 channel. Just wanted to verify if this would be a good match for the subwoofers. Thank you.

 
Just hope you don't have to send it in to Crescendo for any repairs, lol

EDIT:

That's probably the simplest board I've ever seen, besides old school stuff

S1500_003_SSA__88138.1410842556.1280.1280.png


 
Just hope you don't have to send it in to Crescendo for any repairs, lol
EDIT:

That's probably the simplest board I've ever seen, besides old school stuff

S1500_003_SSA__88138.1410842556.1280.1280.png
I remember when the BC2000 was less than that. I smoked one and Navid just sent me a new one. Didn't even ask for my blown one.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Well I’m on the gp website and I’m looking and I found the one I’m going to get but I’m unsure if the length I should get. Standard is 4ft should...
10
1K
So you have an 800 watt sub (1600 is a peak spec, ignore it) the SVR-10 - 800 RMS dual 2VC ohm wired in parallel for a 1 ohm load paired with an...
7
88

About this thread

jakekruika

Junior Member
Thread starter
jakekruika
Joined
Location
Wilkes-Barre, PA
Start date
Participants
Who Replied
Replies
5
Views
1,299
Last reply date
Last reply from
LosIsATool
1716159391521.png

Doxquzme

    May 19, 2024
  • 0
  • 0
Screenshot_20240520_000638_Adobe Acrobat.jpg

Dylan27

    May 19, 2024
  • 0
  • 0

New threads

Top