RF 1000a2 left channel help

  • 1
    Participant count
  • Participant list

xxHOBOPROxx

Junior Member
Hey everyone I need help on fixing my amp! It has signal in because at super low volume I can hear it but as the music gets louder all of a sudden it begins to crackle then starts popping. So it's not the gain because i checked it and my wiring is cur ect because the right challenge pumps out 550 watts. So please help!!!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Some of it plays well, some not so well lol. New decaf going around of "Break the knob off!" I have been playing and like it.
8
1K
Sounds like you shorted the other channel so check you connections. Don't ask just look. Will solve your problem Every time. If you ever short out...
9
2K
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
148
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
381
Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
768

About this thread

xxHOBOPROxx

Junior Member
Thread starter
xxHOBOPROxx
Joined
Location
Birmingham, AL
Start date
Participants
Who Replied
Replies
0
Views
1,295
Last reply date
Last reply from
xxHOBOPROxx
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top